This article is about the OT-One.
It's no-longer sold or actively supported by Opentrons, but we've kept this article here to help existing users. Please see our OT-2 Support articles for the most up to date information!
Welcome to the Opentrons family!
Here is a step by step video on how to set up your OT-One
You can also use the instructions below:
You will need a pair of scissors to cut the tape along the top lid of the box.
________________________________________________________
Remove the top layer of foam
_______________________________________________________
Cut the Zip tie securing the bag enclosure
________________________________________________________
Remove the large piece of foamÂ
________________________________________________________
Time to take your robot out of the box! Lift robot by Y axis bars.
**Pro tip: Grab a labmate for assistance, the OT-One is approximately 20kg!
________________________________________________________
Place the robot on your lab bench
________________________________________________________
Cut plastic wrap securing the accessories.
________________________________________________________
Remove the foam box with accessoriesÂ
________________________________________________________
Remove foam around the motor controller box and bottom corner foam