Welcome to the Opentrons family!

Here is a step by step video on how to set up your OT-One

You can also use the instructions below:

You will need a pair of scissors to cut the tape along the top lid of the box.
________________________________________________________

Remove the top layer of foam

_______________________________________________________

Cut the Zip tie securing the bag enclosure

________________________________________________________
Remove the large piece of foam 

________________________________________________________
Time to take your robot out of the box! Lift robot by Y axis bars.
**Pro tip: Grab a labmate for assistance, the OT-One is approximately 20kg!

________________________________________________________
Place the robot on your lab bench

________________________________________________________
Cut plastic wrap securing the accessories.

________________________________________________________
Remove the foam box with accessories 

________________________________________________________
Remove foam around the motor controller box and bottom corner foam



Did this answer your question?